Cubik Studio

Hello

I just bought Cubik Studio today and I keep getting an install failure.

The failure message says:

Installation failed on file (CubikStudio.exe):
Access to the path "C:\Program Files\Cubik Studio\CubikStudio.exe.tmp" is denied.

To answer your first question, Yes I made sure all firewalls were turned off on my PC.

My system is:
Windows 10 64bit
Intel i5 processor
1 TB hard drive
16 GB ram

Please advise as I am very eager to start using my new software.

Sincerely,

Derrell Garms

As it says it doesn't have permission to to access the file (probably when it's moving it from the temp d/l location to where you run CubikUpdater from).

This is usually caused by Windows' primitive file system protection.

Try moving Cubik Studio to another folder, such as on your Desktop, Documents or Downloads folder.

Thanks Hanfox

I will give that a try and see if that fixes the issue.


D. Garms

That did the trick HanFox. I just created a folder on my desktop and it finished the install and is up & running.

Thank you again!

D.Garms